Overview 8 matches · 0 protected · 0 exploited · 0 CISA KEV · 0 public PoC · 0 EPSS ≥ 0.5
8matches
0protected0.0%
0exploited0.0%
0CISA KEV0.0%
0public PoC0.0%
0EPSS ≥ 0.50.0%
Protected by Waratek
0
0.0%
Rule in development
0
0.0%
Mitigation candidate
0
0.0%
No exploit published
8
100.0%
Outside Waratek scope
0
0.0%
Not applicable
0
0.0%
Withdrawn CVE
0
0.0%
blocked by ARMR today
0
0.0%
partly blocked
0
0.0%
not blocked
8
100.0%
not established
0
0.0%
unrecorded
0
0.0%
Exploited
0
0.0%
Working exploit published
0
0.0%
Proof of concept only
0
0.0%
Forecast only
0
0.0%
No public exploit
8
100.0%
split by
peak 2 / quarter
Q2 162
No exploit published2
Critical1
Medium1
not blocked2
No public exploit2
Q3 160
Q4 160
Q1 170
Q2 171
No exploit published1
High1
not blocked1
No public exploit1
Q3 170
Q4 172
No exploit published2
Critical1
High1
not blocked2
No public exploit2
Q1 181
No exploit published1
Medium1
not blocked1
No public exploit1
Q2 181
No exploit published1
High1
not blocked1
No public exploit1
Q3 180
Q4 180
Q1 191
No exploit published1
High1
not blocked1
No public exploit1
Q2 16Q3 16Q4 16Q1 17Q2 17Q3 17Q4 17Q1 18Q2 18Q3 18Q4 18Q1 19
| CVE | Severity | Published▾ | Status | Exploitation | Description |
|---|---|---|---|---|---|
| CVE-2019-0200 | High | 2019-03-06 | No exploit published | No public exploit | A Denial of Service vulnerability was found in Apache Qpid Broker-J versions 6.0.0-7.0.6 (inclusive) and 7.1.0 which allows an unauthenticated attacker to crash the broker instance by sending specially crafted commands using AMQP protocol versions below 1.0 (AMQP 0-8, 0-9, 0-91 and 0-10). Users of Apache Qpid Broker-J versions 6.0.0-7.0.6 (inclusive) and 7.1.0 utilizing AMQP protocols 0-8, 0-9, 0-91, 0-10 must upgrade to Qpid Broker-J versions 7.0.7 or 7.1.1 or later. |
| CVE-2018-8030 | High | 2018-06-20 | No exploit published | No public exploit | A Denial of Service vulnerability was found in Apache Qpid Broker-J versions 7.0.0-7.0.4 when AMQP protocols 0-8, 0-9 or 0-91 are used to publish messages with size greater than allowed maximum message size limit (100MB by default). The broker crashes due to the defect. AMQP protocols 0-10 and 1.0 are not affected. |
| CVE-2018-1298 | Medium | 2018-02-09 | No exploit published | No public exploit | A Denial of Service vulnerability was found in Apache Qpid Broker-J 7.0.0 in functionality for authentication of connections for AMQP protocols 0-8, 0-9, 0-91 and 0-10 when PLAIN or XOAUTH2 SASL mechanism is used. The vulnerability allows unauthenticated attacker to crash the broker instance. AMQP 1.0 and HTTP connections are not affected. An authentication of incoming AMQP connections in Apache Qpid Broker-J is performed by special entities called "Authentication Providers". Each Authentication Provider can support several SASL mechanisms which are offered to the connecting clients as part of SASL negotiation process. The client chooses the most appropriate SASL mechanism for authentication. Authentication Providers of following types supports PLAIN SASL mechanism: Plain, PlainPasswordFile, SimpleLDAP, Base64MD5PasswordFile, MD5, SCRAM-SHA-256, SCRAM-SHA-1. XOAUTH2 SASL mechanism is supported by Authentication Providers of type OAuth2. If an AMQP port is configured with any of these Authentication Providers, the Broker may be vulnerable. |
| CVE-2017-15702 | Critical | 2017-12-01 | No exploit published | No public exploit | In Apache Qpid Broker-J 0.18 through 0.32, if the broker is configured with different authentication providers on different ports one of which is an HTTP port, then the broker can be tricked by a remote unauthenticated attacker connecting to the HTTP port into using an authentication provider that was configured on a different port. The attacker still needs valid credentials with the authentication provider on the spoofed port. This becomes an issue when the spoofed port has weaker authentication protection (e.g., anonymous access, default accounts) and is normally protected by firewall rules or similar which can be circumvented by this vulnerability. AMQP ports are not affected. Versions 6.0.0 and newer are not affected. |
| CVE-2017-15701 | High | 2017-12-01 | No exploit published | No public exploit | In Apache Qpid Broker-J versions 6.1.0 through 6.1.4 (inclusive) the broker does not properly enforce a maximum frame size in AMQP 1.0 frames. A remote unauthenticated attacker could exploit this to cause the broker to exhaust all available memory and eventually terminate. Older AMQP protocols are not affected. |
| CVE-2016-8741 | High | 2017-05-15 | No exploit published | No public exploit | The Apache Qpid Broker for Java can be configured to use different so called AuthenticationProviders to handle user authentication. Among the choices are the SCRAM-SHA-1 and SCRAM-SHA-256 AuthenticationProvider types. It was discovered that these AuthenticationProviders in Apache Qpid Broker for Java 6.0.x before 6.0.6 and 6.1.x before 6.1.1 prematurely terminate the SCRAM SASL negotiation if the provided user name does not exist thus allowing remote attacker to determine the existence of user accounts. The Vulnerability does not apply to AuthenticationProviders other than SCRAM-SHA-1 and SCRAM-SHA-256. |
| CVE-2016-4432 | Critical | 2016-06-01 | No exploit published | No public exploit | The AMQP 0-8, 0-9, 0-91, and 0-10 connection handling in Apache Qpid Java before 6.0.3 might allow remote attackers to bypass authentication and consequently perform actions via vectors related to connection state logging. |
| CVE-2016-3094 | Medium | 2016-06-01 | No exploit published | No public exploit | PlainSaslServer.java in Apache Qpid Java before 6.0.3, when the broker is configured to allow plaintext passwords, allows remote attackers to cause a denial of service (broker termination) via a crafted authentication attempt, which triggers an uncaught exception. |